Dexter 12SD2-25RC.1A Instructions D'origine page 100

changed during drilling, this could cause the bit to snap off, blocking the hole and perhaps causing injury.
- Reduce pressure as the drill is about to break through the item being drilled.
- Don't force the drill, let it work at its own pace.
- Keep the drill bit sharp.
DRILLING WOOD
For maximum performance when drilling larger holes, use auger bits or spade bits for wood drilling.
- Set the tool to the drill mode.
- Begin drilling at a very low speed to prevent the bit from slipping off the starting point. Increase the
speed as it bites into the wood.
- When drilling through holes, place a block of wood behind the work piece to prevent ragged or splintered
edges on the back of the hole.
EN
DRILLING METAL
For maximum performance, use HSS drill bits for metal drilling.
- Set the tool to the drill mode.
- Mark off the center of the hole using a center punch.
- Use a suitable lubricant for the material you are working on.
- Begin drilling at a very low speed to prevent the bit from slipping off the starting point.
- Always clamp sheet metal. Support thin metal with a block of wood to avoid distorting it.
SPECIAL SAFETY INSTRUCTIONS FOR BATTERY PACK AND CHARGER
a) This appliance can be used by children aged from 8 years and above and persons with reduced
physical, sensory or mental capabilities or lack of experience and knowledge if they have been
given supervision or instruction concerning use of the appliance in a safe way and understand the
hazards involved.
b) Children shall not play with the appliance. Cleaning and user maintenance shall not be made by
children without supervision.
c) Before the use of the charger and the battery pack, read the instruction manual for it carefully.
d) During the charge process, the current used should correspond to the current of the battery
charger.
e) Never let moisture, rain orsplashed water reaches the charging location.
f) The ambient temperature must not exceed 50°C. Never expose the device to direct insulation.
g) Only switch off the current when the battery pack has been inserted into the box or has been pulled
out of the box.
h)Storage-battery pack, which are defective or damaged or can no longer be recharged, must be
disposed of as hazardous waste. Hand them over at a special collection point Never harm our
environment.Do not throw unusable storage-battery pack away into the domestic waste,into fre
or into water.
i) If the electrical cable is damaged, the wire may only be replaced by the supplier or by his repair
workshop. Have repairs carried out only by an authorized specialist only.
j) Use only storage-battery pack, which have been produced by the original manufacturer.
k) Always keep the surface of the charger free from dust and dirt.
l) Insert the battery pack into the charger. Follow the guidelines provided concerning polarity.
m) Always remove battery pack before working on the machine.
n) When the battery pack is outside the drill, cover the contacts to avoid short circuits (e.g. from tools)
0)Do not throw Li-ion batteries into water or fire, risk of explosion!
p)Protect the battery pack from impacts, and don't open it.
q)Never discharge the battery pack completely and recharge occasionally if not used for aprolonged
period.
r) Do not recharge non-rechargeable batteries, as they can overheat and break.
RESIDUAL RISKS: Even when the tool is used as prescribed it is not possible to eliminate all residual
risk factors. The following hazards may arise in connection with the tool's construction and design:
100