Beta Motorcycles RR 250 2T 2017 Mode D'emploi page 148

4
GB
2mm
fRONT BRaKE liNiNG CONTROl
In order to verify the wear condition of front
brake is enough to view the caliper from
the bottom, where is possible to glimpse
the brake lining tails which will have to
show a brake of 2 mm in thickness. If the
stratum is lesser let's start replacing them.
Note:
Perform the check according to the times
shown in the table on page 79.
To replace, contact authorised Betamotor
customer service.
BRaKE diSC ThiCKNESS
CONTROl
Periodically verify disc condition. In case
signs of damage , veins, or deformations
are present, proceed with replacement.
Verify disc thickness. The minimum thick-
ness is engraved on the disc.
Once the limit is in proximity or has been
reached, proceed with brake disc replace-
ment.
For replacement, contact an authorised
Betamotor after-sales service centre.
58