Beta Motorcycles RR 250 2T 2017 Mode D'emploi page 133

adjuSTiNG ThE COmpRESSiON
dampER
The hydraulic compression damper deter-
mines the behaviour of the telescopic fork
during compression and can be adjusted
by means of screw B located at the lower
end of the fork legs. Turning the screw
clockwise increases the action of the com-
pression damper; turning it anticlockwise
decreases the action of the compression
damper.
For standard calibration, refer to page 11.
ShOCK aBSORBER
adjuSTiNG ThE REBOuNd
dampER
Turn screw a to adjust the hydraulic re-
bound damper.
Turning the screw anticlockwise (out) de-
creases the damping effect.
For standard setting, refer to page 12.
adjuSTiNG ThE hydRauliC
COmpRESSiON dampER (hiGh
aNd lOw SpEEdS)
Adjustment for low compression speed:
•Using a screwdriver, loosen screw C
by turning it clockwise to increase the
hydraulic compression damper.
For standard setting, refer to page 12.
Adjustment for high compression speed:
•Turn knob d anticlockwise to decrease the
hydraulic compression damper.
For standard setting, refer to page 12.
C
d
WARNING:
Starting from the standard position, turn
the knob anticlockwise (with a closing
action), the center screw will have an
integral movement, then will rotate with
the knob.
For standard setting, refer to page 12.
43
B
a
3
GB