Beta Motorcycles RR 250 2T 2017 Mode D'emploi page 130

3
To properly adjust the idle speed, follow these steps:
• Tighten the air adjustment screw no. 2 fully and then loosen it up to the value described
in the carburetor setting table (page 12)
• Warm the engine for approx. 5 minutes, until the operational temperature is attained.
• Slowly turn the air adjustment screw 2 clockwise, until idling starts diminishing.
• Mark the position, then slowly turn the air adjustment screw no. 2 counterclockwise, until
idling decreases again.
• Adjust the screw between these two positions, at the highest idling point..
If a remarkable increase in the rpm occurred during the adjustment above, idling is to be
reduced and taken back to the normal level, and then execute the above procedure.
If no satisfactory results are obtained after the procedure, this may be due to an incorrect
slow-running jet.
If the air adjustment screw has been thoroughly tightened, but the rpm have not varied, a
lower size slow-running jet is to be used.
Execute the adjustment procedure again after replacing the jet.
NOTE:
The correct idling should be between 1700 and 1800 rpm.
GB
40