Publicité
Les langues disponibles
Les langues disponibles
INSTRUCTIONS FOR USE
TECHNICAL DATA
VIEWING AREA
POWER SUPPLY
LIGHT STATE (DIN EN 379)
DARK STATE (DIN EN 379)
SWITCH TIME (DIN EN 379)
DELAY TIME (DARK TO LIGHT)
OPERATING TEMPERATURE
STORAGE TEMPERATURE
WEIGHT
USE
HEADGEAR ADJUSTMENT
• The headgear size can be manually adjusted to fit different wearers.
• Slightly rotate the knob on the back of the headgear, and adjust the width of the headband, so as to feel comfortable.
• The sides of the mask accommodate 3 holes for adjusting the viewing angle. Place the reference pins of the headband in the
most suitable hole. The ideal viewing angle is the one where the filter is perpendicular to the welding surface.
FILTER SETTINGS
LEGEND
1. Self-test button
2. Delay time adjusting knob
3. Sensitivity adjusting knob
4. LCD
5. lithium battery
6. Low voltage indicator
7. Solar cell
8. Auto-darkening filter
9. Arc sensor
Mode selection
Set such mode as required for the welding job to be carried out as follows:
• Select shade number 9-13 by means of the adjustment knob outside the mask, being careful not to set the "GRIND" function
(dark value 4).
• To select the suitable shade number, follow the instructions contained in Table 1:
98 x 43 mm
SOLAR CELL, 2 x CR2032 3V
4
9 – 13
1/1000s (1/25000s, ANSI z87.1)
0.25s ÷ 1.0s
-5°C +55°C
-20°C +70°C
0.480 kg
Table 1
EN
9
Publicité
