Brooks Instrument 48 Serie Manuel D'installation Et D'utilisation page 13

Installation and Operation Manual
X-TMF-4800-MFC-eng
Part Number: 541B072AAG
October, 2017
2-1 General
2-2 Receipt of Equipment
2-3 Recommended Storage Practice
This section contains the procedures for the receipt and installation of the
instrument. See Section 1 for dimensional and connection requirements.
Do not attempt to start the system until the instrument has been
permanently installed. It is important that the start-up procedures be
followed in the exact sequence presented.
When the equipment is received, the outside packing case should be
checked for damage incurred during shipment. If the packing case is
damaged, the local carrier should be notified at once regarding his liability.
A report should be submitted to the nearest Brooks Instrument location
listed on the Global Service Network page on our website:
BrooksInstrument.com/GlobalSupportCenters
Remove the envelope containing the packing list. Carefully remove the
instrument from the packing case. Make sure spare parts are not discarded
with the packing materials. Inspect for damaged or missing parts.
If intermediate or long-term storage of equipment is required, it is
recommended that the equipment be stored in accordance with the
following conditions:
a. Within the original shipping container.
b. Stored in a sheltered area, preferably a warm, dry, heated warehouse.
c. Ambient temperature 21°C (70°F) nominal, 32°C (90°F) maximum,
7°C (45°F) minimum.
d. Relative humidity 45% nominal, 60% maximum, 25% minimum.
Section 2 Installation
®
Brooks 48xx Series
2-1