Publicité
Les langues disponibles
Les langues disponibles
> Manual
FIG. 1 – 5 (See picture page 2)
Preparing the hair
• Wash your hair and dry it well.
• Comb your hair thoroughly. Do not use hairspray or other flammable chemical hair care products.
Drying hair
Your appliance may also be used without attachments as a normal hair dryer.
• For this, press the key "push" and turn the top until the stop. Pull the attachment from the
appliance (see figs. 1/2).
To re-insert the round brush proceed in reversed sequence (see fig. 3). Turn the top until the stop
and ensure that the markings are aligned.
Round brushing
WARNING!
Danger of burns from hot appliance components!
Never grasp at the round brush, especially not at the tip, when the appliance is on.
Brush f 30 mm ø or g 38 mm ø must be fitted for round brushing.
• Place the hair strands over the brush and thoroughly brush from the roots to the tips before rolling.
Then beginning with the hair tips roll until a curl is formed. Turn the appliance on (position „ "
or„ ") and allow the warm air to take effect until the hair is dry (see fig. 4). For fixation, press the
function switch a "COOL" and let the cold air take effect. Now press the button for automatic curl
release and pull the round brush out from the curl (see fig. 5). Switch the appliance off.
Note!
Please pay attention that the hair strands are not too thick.
2-step sliding switch
With the 2-step sliding switch b you can switch the appliance on and select the desired position.
O = Appliance is switched off
I = low air volume, 500 watt power
I + COOL = low air volume + cool position, 250 watt power
2 = large air volume 1000 watt power
2 + COOL = large air volume + cool position, 500 watt power
COOL SHOT push button
With the COOL SHOT push button a you can lower the air temperature while the appliance is switched
on.
English • 47
Publicité
