Connection With Hmi / Bhp; Phase 1 - Electrical Connections - AERMEC VMF-485LINK Manuel D'utilisation

EN
4.

CONNECTION WITH HMI / BHP

4.1.

PHASE 1 - Electrical connections

HMI / BHP control panel
2020-02-20 08:52
-
Rear of the
panel
NOTES:
1. for HMI or BHP units, an IC-2P accessory connector available as an accessory is required;
2. before proceeding further, make sure that the SW1 dip-switches are correctly configured:
SW1 (HMI or BHP with integrated domestic hot water management)
DIP 1
ON
SW1 (HMI or BHP without integrated domestic hot water management)
DIP 1
ON
22
0.0°C 0.0°C
+
25°C
IC-2P
(accessory)
DIP 2
OFF
DIP 2
OFF
GND GND
DIP 3 DIP 4
OFF ON
DIP 3 DIP 4
OFF OFF
Vin: 230 Vac
50/60 Hz
Imax: 0.15 A
Previous node
VMF network
Subsequent node
VMF network