Publicité
Les langues disponibles
Les langues disponibles
5.3 Parameter settings
There are two levels of protection for parameters:
a) User (U): with immediate access, User-changeable;
b) Password protected Factory/Service (F/S): password required for access; Factory/Service use
only.
5.3.1 Condensate drain
It is possible to modify the operating modes of the drain, using the
"TIME" menu. There are two operating modes:
1. TIMED (CHd = ON) - with draining at intervals and settable time; in
this confi guration keep pressed
to force the drain to work;
2. EXTERN (CHd = OFF) - if there is an external drain.
For choosing the set proceed as follows (or see the fl ow chart):
set
esc
Press buttons
and
together to enter on submenu.
Using buttons
and
select "Par" and press
Using buttons
and
select "
" and press
TIME
Using buttons
and
select the code to change and press
Using buttons
and
change the value and press
esc
Press
to confi rm and exit.
In the same way it is possible to change interval and discharge times of the drain.
Parameter table "TIME"
Code
Defi nition
dON
Time ON Drain (sec.)
dOFF
Time OFF Drain( 1=10 sec.)
CHd
Confi guration drain
English
set
to confi rm.
set
to confi rm.
set
to confi rm.
set
to confi rm.
Default
Min
Max.
5
1
60
12
2
270
TIm
TIm
CON
SPS026-ES / SPS100 ES
5.3.2 Software menu
It is possible to see the software version and set the dryer for the remote control or the supervisor in
the menu "CF9".
set
esc
Press buttons
and
together over 5 seconds to enter on submenu.
Using buttons
and
select "Par" and press
Using buttons
and
select "CF9" and press
Using buttons
and
select the code to change and press
Using buttons
and
change the value and press
esc
Press
to confi rm and exit.
Parameter table "CF9"
Code
Defi nition
VER
Software Version
SOFt
Software type
rE
On/Off remote (Table 1)
SUP
ON/OFF supervisor (Modbus)
Table 1
0
On/Off remoto disable
1
On/Off remote enable, local On/Off enable
2
On/Off remote enable, local On/Off disable
Machine status
To get the machine status signal you
have to connect to the following powe-
red contacts (0-10V):
1) A1 on J3 on clamp A04
2) X1 on clamp GND
State ON (contact closed =10V)
State OFF (contact open = 0V)
* in case of no power supply or loss.
set
to confi rm.
set
to confi rm.
set
to confi rm.
set
to confi rm.
Default
Min
1.0
---
1
---
0
0
OFF
OFF
On/Off remote mode
Machine
power
ON/OFF
energy
status
supply
display
saving
ON
YES
ON
not
infl uent
OFF
NO*
ON
OFF
YES
OFF
OFF
NO*
OFF
Max.
---
---
2
ON
presence
of alarms
not
infl uent
5/10
Publicité
