SOMFY SONESSE2 40 ZIGBEE HP Notice page 7

Les langues disponibles

SONESSE2 40 ZIGBEE HP

2.5.Commissioning with a control point only (without TaHoma pro

application)

This chapter describes the commissioning of the drive with a control point only, without using TaHoma pro

application, in the case of TaHoma ready solution.

2.5.1.Link creation between a drive and a control point

The following steps describe how to program a drive that is not set or paired, with an unpaired control point.

CAUTION

Settings are not possible if the control point batteries are too low.

1] Plug in the power supply of the drive.

g If the drive is not set or paired, once plugged in, it goes into programming

mode during 3 min, and its LED blinks orange.

NOTICE

If the drive has left the programming mode, its LED is not blinking:

• Press and hold the PROG button on the drive until the motorised product

moves up and down briefly and its LED blinks orange : the drive is in

programming mode during 3 min.

2] Bring the control point close to the drive then briefly press simultaneously

the Up and Down buttons on the control point: the control point looks for

the closest drive in programming mode.

g When found, the feedback LED on the control point blinks in green, the

drive LED flashes in green, and the motorised product moves up and

down briefly.

g Then the feedback LED on the control point blinks in orange slowly as

long as it is in setting mode.

NOTICE

If the control point does not find a drive nearby, the feedback LED of the control point blinks red after a few seconds,

and the motorised product of the drive does not move: repeat the above procedure. (If the drive is still in

programming mode, repeat only step 2).

NOTICE

If the control point does not find the right drive, please refer to chapter Scanning mode.