SOMFY SONESSE2 40 ZIGBEE HP Notice page 5

Les langues disponibles

SONESSE2 40 ZIGBEE HP

CAUTION

• Ensure that the drive-tube assembly is secured onto the end bracket. This operation prevents the tube-drive

assembly from coming out of the end bracket attachment.

• Light gap reduced: Do not pinch cables or be careful they are not in contact with moving parts.

• Do not let the drive-tube hanged by only one side.

2.2.Wiring

PRECAUTION

• Cables which pass through a metal wall must be protected and isolated using a sheath or sleeve.

• Secure cables to prevent any contact with moving parts.

• The drive cable cannot be removed. If it is damaged, return the drive to the After-Sales department.

• Leave the drive power supply cable accessible: it must be easily replaceable.

• Connection must be done in a junction box.

1] Switch off the power supply.

2] In the case of using an extension cable with fast connector plug the extension

cable with female i fast connector to the motor extension cable with male j

fast connector.

3] Connect the plug k of the extension cable to the wall socket power supply or

connect the drive according to the information in the table below:

120 V 〜 60 Hz

220 V 〜 60 Hz

230 V 〜 50 Hz

2.3.Commissioning of a Zigbee drive

Regarding the commissioning of a Zigbee drive, it can be done in 2 different ways :

▪ Either commissioning with TaHoma pro application, which is recommended because it is easier and more complete.

▪ Either commissioning with a control point.

Please refer to the corresponding section according to the selected commissioning mode.

In an installation with Zigbee drives, 2 solutions are available to the user: TaHoma switch solution and TaHoma ready

solution.

TaHoma switch solution is the solution in connected mode, with a TaHoma switch in the installation that allows the user to

control all his Zigbee products through the TaHoma application.

The other solution, without TaHoma switch is called TaHoma ready. It allows the user to control his Zigbee drives only with

control points. But this installation can be switched to connected mode afterwards by adding a TaHoma switch later.

Neutral (N)

White

Blue

Live (L)

Black

Brown

OFF