Télécharger Imprimer la page

Singer X5004-HD Mode D'emploi page 34

Publicité

Les langues disponibles

Les langues disponibles

22. Starting and Ending Seams
To Start a Seam
To start a seam on most fabrics, first bring the
thread tail under the presser foot and then to
the left of the machine.
Hold the thread tail and step on the foot controller
to begin sewing.
Sew until you have created a 3" (7.5 cm) chain.
Place the fabric on the feed dogs in front of the
foot. Start sewing.
Note: * For heavy or thick fabrics, it is recommended
to use SINGER needles #2022 size 100/16.
* Heavy or thick fabrics may be more difficult
to feed than others. In these cases, start by
cutting a notch at the beginning of the
seam about 1" (2.5 cm) down from the top
of the fabric, and along the seam line.
* Lift the presser foot and raise the needles.
Place the notch so that the top edge of the
fabric is in front of the needles, with the cut
edge lined up next to the blade.
* Lower the presser foot and sew.
To End a Seam
To end a seam, continue sewing past the end
of the fabric until the thread chain forms.
Cut the thread, leaving at least 3" (7.5 cm) at
the end of the fabric.
30

Publicité

loading