Cleanup; Special Cleanup Instructions For Use With Flammable Solvents; Cleaning The Sprayer; Cleaning The Outside Of The Unit - Titan Tool ProMark Série Mode D'emploi

ProMark
7

cleANup

The sprayer, hose, and gun should be cleaned
thoroughly after daily use.
permits material to build up, seriously affecting
Attention
the performance of the unit.
Always spray at minimum pressure with the gun
nozzle tip removed when using mineral spirits
or any other solvent to clean the sprayer, hose,
or gun. Static electricity buildup may result in a
fire or explosion in the presence of flammable
vapors.
7.1
SpecIAl cleANup INSTrucTIoNS for uSe
WITh flAmmABle SolVeNTS
•
Always flush spray gun preferably outside and at least one
hose length from spray pump.
•
If collecting flushed solvents in a one gallon grounded
metal container, place it into an empty five gallon container,
then flush solvents.
•
Area must be free of flammable vapors.
•
Follow all cleanup instructions.
7.2

cleANINg The SprAyer

1. Make sure a solvent flush (section 6.3) has been performed.
2. Remove the gun tip and tip guard and clean with a brush
using the appropriate solvent.
3. Place the siphon tube into a container of the appropriate
solvent.
Use only compatible solvents when cleaning
out oil based enamels, lacquers, coal tar, and
epoxies. Check with the fluid manufacturer for
Attention
the recommended solvent.
4. Place the bleed hoses into metal waste containers.
5. Set the pressure to minimum by turning the pressure
control knob fully counterclockwise.
6. Open the spray material shutoff valves on the high
pressure filters.
7. Start the engine (see section 5.1).
8. Allow the solvent to circulate through the sprayer and
flush the paint out of the bleed hose into the metal waste
container.
9. Switch the unit OFF (turn the ignition key OFF).
10. Close the spray material shutoff valves on the high
Failure to do so
11. Start the engine (see section 5.1).
12. Trigger the gun into the metal waste container until the
13. Continue to trigger the spray gun into the waste container
14. Relieve the pressure in the system by opening the hydraulic
15. Store the sprayer in a clean, dry area.
Attention
7.3
Attention
Wipe down unit externally with a cloth which has been
immersed in a suitable cleaning agent.
pressure filters.
Earth the gun by holding it against the edge
of the metal container while flushing. Failure
to do so may lead to a static electric discharge,
which may cause a fire.
spray material is flushed out of the hose and solvent is
coming out of the gun.
until the solvent coming out of the gun is clean.
For long-term or cold weather storage, pump
i
mineral sprits through the entire system.
motor shutoff valves (A and B side).
Do not store the sprayer under pressure.
Relieve pressure at the spray material shutoff
valves (open the valve) located on the high-
pressure filters. Once pressure is relieved, close
the valves again.

cleANINg The ouTSIDe of The uNIT

Never spray down the unit with high-pressure or
high-pressure steam cleaners.
Do not put the high-pressure hose into solvents.
Use only a wet cloth to wipe down the outside of
the hose.
cleanup
29