Position The Spray Gun And Bead Dispenser Gun; Lubricate The Packings; Hydraulic Motor - Titan Tool ProMark Série Mode D'emploi

ProMark
4.4
poSITIoN The SprAy guN AND BeAD
DISpeNSer guN
The final configuration of the spray gun(s) and
i
bead dispenser gun(s) will depend upon your
spraying needs.
SprAy guN coNfIgurATIoN
•
The height of the spray gun affects the width of the spray
pattern. The closer the gun is to the spraying surface, the
smaller the line width, and vice versa.
•
Spray tip size also affects line width.
•
If using a two-gun system, the guns can be placed side-by-
side to create wider single lines, or further apart to create
narrower double lines.
•
Adjust the height of the spray gun by adjusting the
various clamps vertically or horizonally, or adjust vertically
everything all at once by turning the SmartArm™ crank.
BeAD DISpeNSer guN coNfIgurATIoN
•
The bead dispenser gun is generally positioned behind the
spray gun. This difference in position is known as "lead
lag".
•
If using a ProMark 150, that lag can be accounted for by
using the DataLogger™ (see section 3.5) so the beads and
spray material are applied together at the beginning and
the end of a spraying pass.
•
If using a ProMark 100 without DataLogger, the bead
dispenser gun and spray gun can be adjusted to be closer
together to minimize lead lag.
fIgure 8
•
The dispersion width of the beads can be adjusted by
moving the side walls of the dispenser gun in (narrower)
or out (wider).
leAD lAg
4.5

luBrIcATe The pAckINgS

The packings should be lubricated prior to every
i
use.
1. Fill the hydraulic motor oil cup 1/2 full with Piston Lube
(P/N 314-480, included). This extends packing life.
fIgure 9
Piston Lube prevents increased wear and tear to
the packings.
Attention
system preparation

hyDrAulIc moTor

oIl cup
23