Check Hydraulic Fluid Level; Final Checks - Titan Tool ProMark Série Mode D'emploi

system preparation
4.6

check hyDrAulIc fluID leVel

Check the hydraulic fluid level daily before
i
starting the sprayer.
1. Remove the hydraulic pump dipstick. The hydraulic fluid
level should be at the "Full" mark on the dipstick. Refer
to the Maintenance section of this manual for hydraulic
system maintenance instructions.
fIgure 10
Use of Titan's Coolflo™ Hydraulic Fluid (P/N 430-
361) is mandatory in the hydraulic system.
Do not use any other hydraulic fluid. Use of any
Attention
other hydraulic fluid may seriously damage the
hydraulic system and will void the warranty.
24
4.7
1. Check the engine oil level daily before starting the sprayer.
2. Make sure the sprayer is grounded/earthed. All sprayers
DIpSTIck

fINAl checkS

The gasoline engine oil level is determined by the engine
manufacturer. Refer to the engine manufacturer's service
manual supplied with this sprayer.
are equipped with a grounding/earthing chain which
should be touching the ground. Check your local electrical
regulations for detailed earthing instructions.
Proper grounding/earthing is important. The
passage of some materials through the nylon
fluid hose will build up a static electric charge,
which if discharged, could ignite solvent vapors
present and create an explosion.
ProMark