Publicité
Les langues disponibles
Les langues disponibles
Copy parameter sets from the keypad to the standard device
Step
1.
Connect the keypad to
standard device 2
2.
Inhibit the controller
3.
Select the "Load/Store"
submenu 7.1 in the "Param
managm" menu 7
4.
Change to the code level
5.
Change to the parameter level
6.
Select the correct copy function
l
Copy all available parameter sets (PAR1 ... PAR4, FPAR1 if applicable) into the standard
device:
– Standard device with
function module
Application I/O,
INTERBUS,
PROFIBUS−DP, LECOM−B,
DeviceNet, CANopen
– Standard device with all
other function modules
l
Only copy the module−specific parameter set FPAR1 to the function module:
– Only possible for
standard devices with
function module
INTERBUS,
PROFIBUS−DP, LECOM−B,
DeviceNet, CANopen:
EDK9371BC DE/EN/FR 3.1
Parameterisation 8200 vector/8200 motec
Key sequence
S
z y Z Y
Z
V
z
z
l
Transmit parameter sets
Action
The drive coasts
Change to the "Load/Store" submenu
using the arrow keys
"Param managm" is displayed in C0002
"0" and "READY"are displayed
The settings stored in the standard
device or in the function module are
overwritten.
Copy PAR1 ... PAR4 and FPAR1:
ð
Set "70" "Key−>F1&PAR1−4"
Copy PAR1 ... PAR4:
ð
Set "10" "Keypad−>PAR1−4"
Copy FPAR1:
ð
Set "40" "Keypad−>FPAR1"
7
81
Publicité
