CONSTRUCTA CF110253 Notice D'utilisation page 49

Cleaning the cooking compartment
Caution!
Risk of damaging the surface. Do not clean the appliance while
still warm, even if using oven cleaners specially intended for
this purpose.
Notes
Due to its technical properties, the enamel may exhibit colour
■
variations. However, this has no effect on the function.
The edges of thin trays may be rough. Anti-corrosion
■
protection is still guaranteed, however.
Appliance part Cleaning agent/aid
Enamel surfaces Apply washing-up liquid or vinegar solution
with a soft, damp cloth or chamois; dry with
a soft cloth. Soften baked-on food residues
with a damp cloth and detergent. Leave the
cooking compartment open to dry after
cleaning.
We recommend using oven cleaner if the
oven is very dirty. Observe the manufac-
turer's instructions when cleaning with an
oven cleaner.
Door seal Hot soapy water
Hook-in racks Hot soapy water:
Soak and clean with a dish cloth or brush.
Telescopic Hot soapy water:
shelves Clean with a dish cloth or a brush.
Do not remove the lubricant while the pull-
out rails are pulled out – it is best to clean
them when they are pushed in.
Do not soak or clean in the dishwasher.
Accessories Soak in hot soapy water. Clean with a brush
and sponge or wash in the dishwasher.
Keeping the appliance clean
Clean the cooking compartment after each use, as dirt will
bake on the next time it is heated up, and this can only be
removed with difficulty. Always remove flecks of limescale,
grease, starch and albumin (e.g. egg white) immediately.
Where possible use the 3 Hot air operating mode. This
operating mode creates less dirt.
Removing and fitting the appliance door
You can remove the appliance door to clean it more
thoroughly.
:
Risk of injury!
The hinges of the appliance door may snap shut with great
force. Always open the hinge locking lever fully when removing
the appliance door and close it fully after refitting. Do not reach
into the hinge.
:
Risk of injury!
If the appliance door has only been unhinged on one side, do
not reach into the hinge. The hinge can snap back with great
force. Call the after­sales service.
Removing the appliance door
Open the appliance door fully.
1.
Open the locking levers on the left and right-hand side fully.
2.
The hinges are secured and cannot snap closed.
Close the appliance door until resistance becomes
3.
noticeable (figure A).
With both hands, grip the door on the left and right-hand side,
4.
close the door a little more and pull it out (figure B).
$
Fitting the appliance door
Insert the hinges in the left and right-hand holders (figure C).
1.
The notch on both hinges must engage.
Open the appliance door fully.
2.
Close the locking levers on the left and right-hand side fully
3.
(figure D).
&
The appliance door is secured and can no longer be
removed.
Close the appliance door.
4.
Cleaning the door panels
To assist with cleaning, the inner door panel can be removed
from the appliance door.
:
Risk of injury!
The components inside the appliance door may have sharp
edges. Take care not to cut yourself. Wear protective gloves.
:
Risk of injury!
The appliance must not be used again until the door panels
and appliance door have been correctly fitted.
%
'
49