Maintenance And Size Change - FAR EB 310 Mode D'emploi

EB 310 EB 310
MAINTENANCE AND SIZE CHANGE (fig. f4-f5-f6)
Prolonged use of the riveting tool may cause the clamps to slide
along the stem due to built-up grime. You must therefore clean
and lubricate the clamps, or replace them if heavily worn to
the point of preventing correct use.
Use a 27-mm commercial wrench to remove the tube carrying
nozzle (B). Once the tube has been removed, use a commercial
wrench - 16 mm - to remove the cone (L) and extract the clamps
(M). To replace the nozzle (A), use the supplied special key (N)
and place on it the removed nozzle to avoid any loss.
Please note: prolonged use of the riveting tool may cause a
normal wear of the microswitch, of the motor or of the printed-
circuit board inside the handgrip. To avoid a further damage of
the tool, proceed in replacing the microswitch, the motor or the
printed-circuit board (see following chapters).
WARNING!
The riveting tool must be shut off during the
above operations.
f4
B
B
Revision - 04
GB
f5
L
L
WARNING!
If the clamps holding cone is not well
locked, the riveting tool may be seriously
damaged.
f6
A
A
Date 12-2009
M
N
13