Maintenance And Change Of Size - FAR RAC 171 Mode D'emploi

f2
f3
L
10
C
L
Date 09-2008
GB
MAINTENACE AND CHANGE OF SIZE (fig. f4-f5-f6-f7)
The extended utilization of the riveting tool can cause the slipping
of the clamps on the nail due to the deposited impurities. For
this reason, it is necessary to lubricate the clamps after having
cleaned them with benzine or derivates. However, if clamps are
worn out and as a consequence their working is jeopardized,
replace them.
First remove the head which carries the nozzle (H), by means
of a standard spanner of 27 mm. Then, by using two standard
spanners of 18 mm and 14 mm, remove the chuck (M) and extract
the clamps (N).
The riveting tool is supplied, besides the nozzle series for FAR rivets,
with a series of accessories for using the rivets type FARBOLT,
MONOBOLT® and MAGNA-LOK®, respectively of 3/16" and 1/4".
For operating with these rivets you have to replace the nozzles,
the clamps and the cone holding clamps.
When replacing the nozzle (A), use the proper supplied wrench
and screw the removed nozzle in it in order to avoid losing the
nozzle.
WARNING!
Desconnect air feed when performing those
operations.
f4
RAC 171
27 mm
Revision - 04