Télécharger Imprimer la page

Jensen VM9223 Instructions D'opération page 9

Publicité

Les langues disponibles

Les langues disponibles

USING THE TFT MONITOR
Open/Close TFT Monitor
Open TFT Monitor
Press the OPEN (
) button (4) on the front panel or remote
control to slide the monitor panel down to reveal the disc and
SD card slots.
Close TFT Monitor
Press the OPEN (
) button (4) on the front panel or remote
control to close the monitor panel.
Monitor Tilt Angle Adjustment
A known characteristic of LCD panels is the quality of the
display in relationship to the viewing angle. The monitor
angle can be adjusted for optimum viewing using one of the
following methods:
Step by Step Angle Adjustment
Press the ( ) or ( ) button on the remote control (27, 26) to
adjust the tilt angle of the screen one step at a time.
You can also adjust the tilt by pressing and holding the OPEN
(
) button (4) on the front panel. Use the VOL -/VOL+
buttons to adjust the angle of the screen while the red tilt icon
is flashing.
Continuous Angle Adjustment
Press and hold the ( ) or ( ) button on the remote control to
adjust the tilt angle in a continuous motion.
Aspect Ratio
Press the WIDE button (28) on the remote control to adjust
the aspect ratio as follows:
FULL
The entire screen is extended
horizontally to the aspect ratio of 16 to
9. The extension ratio is the same at
any point.
NORMAL
The conventional display image has a
4 to 3 ratio of horizontal to vertical,
leaving a blank area on the right and
left sides of the display.
STANDBY
Screen becomes black. Touch screen
to resume.
All manuals and user guides at all-guides.com
Image Setting
Table 2 shows the video output mode for each playing
source.
Table 2: Video Output Modes
Playing Source
AM/FM TUNER
DVD
BT
AUX IN1
AUX IN2
NAV
CAMERA
*CVBS – Composite Video Baseband Signal
Parameter Adjustment Procedure
1.
Enter Picture Quality Setting Mode:
Press the PIC button (24) on the remote control or the
PIC button (3) on the monitor.
2.
Select Item to Set:
Press the PIC button (3) on the control panel to select
"BRIGHT" or "CONTRAST".
3.
Set Parameters:
Press the +/– buttons (15, 16) on the remote or press
the VOL-/VOL+ buttons (5) on the control panel.
4.
Exit Picture Quality Setting Mode:
Press the PIC button (24) on the remote control or the
PIC button (3) on the monitor
Parking Brake Inhibit
When the pink "Parking" wire is connected to the vehicle
Parking Brake circuit, the front TFT monitor will display video
when the Parking Brake is engaged. (When the pink wire is
grounded via the Parking Brake circuit, video will be
displayed.)
5
Video Output Modes
RGB Mode
RGB Mode
RGB Mode
CVBS Mode
CVBS Mode
CVBS Mode
CVBS Mode
VM9223

Publicité

loading