Indoor Unit Installation; Installation Place - mundoclima MUCOR-48-H9T Manuel D'installation Et L'utilisauter

1.

INDOOR UNIT INSTALLATION

1.1

Installation place

The indoor unit should be installed in a location that meets the
following requirements:
- There is enough room for installation and maintenance.
The ceiling is horizontal, and its structure can endure the weight
-
of the indoor unit.
- The outlet and the inlet are not impeded, and the influence of
external air is the least.
- The air flow can reach throughout the room.
- The connecting pipe and drainpipe could be extracted out easily.
- There is no direct radiation from heaters.
>30(cm)
(min)
( wall or obstacle )
4cm
(min)
50cm(min)
CAUTION
Keep indoor unit, outdoor unit, power supply wiring and
transmission wiring at least 1 meter away from televisions
and radios. This is to prevent image interference and noise
in those electrical appliances. (Noise may be generated
depending on the conditions under which the electric wave
is generated, even if 1 meter is kept.)
NOTE
All the pictures in this manual are for explanation purpose only.
There may be slightly different from the air conditioner you
purchased ( depend on model ). The actual shape shall prevail.
(Ceiling)
Rear
Front
>200cm
50cm(min)
1.2
The dimension of the unit
629mm
1.3 Installation
1. Dismounting the lower front panel
Please take off the lower front panel before connecting
the pipes/wires.
Pull down the two knobs on the grille, take off the
two screws, then the air-inlet grille goes free.
2. Anti-fall. To prevent the falling of the indoor unit, you must:
Pay full attention to the unit due to its elongated shape that
facilitates its fall; Fix the unit firmly to the wall (using two
screws) 3.9 * 25 or on the ground (using the use of M8 screws) to
prevent accidental falls.
screw bolt xing hole
47
455mm
456mm
Air-inlet Grid