Indoor Unit Installation; Installation Place - mundoclima MUCOR-60-H8T Manuel D'installation Et L'utilisauter

INSTALLATION MANUAL
1.

INDOOR UNIT INSTALLATION

1.1

Installation place

The indoor unit should be installed in a location that meets the
following requirements:
- There is enough room for installation and maintenance.
- The ceiling is horizontal, and its structure can endure the weight
of the indoor unit.
- The outlet and the inlet are not impeded, and the influence of
external air is the least.
- The air flow can reach throughout the room.
- The connecting pipe and drainpipe could be extracted out easily.
- There is no direct radiation from heaters.
CAUTION
Keep indoor unit, outdoor unit, power supply wiring and
transmission wiring at least 1 meter away from televisions
and radios. This is to prevent image interference and noise
in those electrical appliances. (Noise may be generated
depending on the conditions under which the electric wave
is generated, even if 1 meter is kept.)
NOTE
All the pictures in this manual are for explanation purpose only.
There may be slightly different from the air conditioner you
purchased ( depend on model ). The actual shape shall prevail.
1.2
The dimension of the unit
610
1.3 Installation
1. Anti-fall. To prevent the falling of the indoor unit, you must:
Pay full attention to the unit due to its elongated shape that
facilitates its fall; Fix the unit firmly to the wall (using two
screws) 3.9 * 25 or on the ground (using the use of 2 M8
screws) to prevent accidental falls.
3. Remove the Pipe Clip before connecting the pipes and wiring;
fix it again after finishing connection.
Use accessories 4 and 8 to connect the pipes/wires on both
sides and back side.
41
Unit: mm