SURE petcare SURE FLAP Cat Flap CONNECT Guide D'utilisation page 11

Table des Matières

Publicité

Les langues disponibles

Les langues disponibles

Adding an indoor only cat
This mode is designed for those cats that need to be kept inside.
2x
1
2
3
You should avoid adding pets when the batteries are low - change the old
batteries before adding a new cat.
Changing the entry/exit permissions for your cat
You can change the permissions for any of your cats at any time if their circumstances
change (i.e. a cat who is allowed to go outside now needs to be kept in due to illness or
injury, or a kitten who was kept inside is now allowed out). To do this simply change the
entry/exit permissions in the product settings section of the Sure Petcare app. If you are
using it as not connected, please add your cat again using the new desired mode.
To perform the adding process with the Sure Petcare RFID Collar Tag simply follow the steps
above and hold the collar tag inside the tunnel, making sure it touches the clear plastic
door. Make sure you are not wearing any metal jewellery as this can cause interference.
If you want to use the Microchip Cat Flap Connect for more than one cat, you are able to
store up to 32 cats in its memory by repeating the process.
In the unlikely circumstance that you need to wipe the memory press and hold the 'Add a
Pet' button for around 10 seconds. Then, the catches will open and close once. At this point
the memory of your Microchip Cat Flap Connect is clear.
After making sure that the manual lock is set to Postion 1
(see step 1 in 'Adding a cat with outdoor access'), remove the
battery compartment cover and press the 'Add a Pet' button
once, wait for the lock to stop moving and then press it again.
When the Cat Flap is in 'Add an indoor only
cat' mode, the catches will move up (lock)
and the indicator light will flash RED once
every second.
Then follow step 4 in 'Adding a cat with
outdoor access' mode to save your cat's
microchip ID in the product's memory.
Once your cat's microchip ID has been
successfully saved, the indicator light will stop
flashing and the catches will stay up (locked).
EN
10

Publicité

Table des Matières
loading

Table des Matières