Zanussi ZRT48201WA Guide D'utilisation page 21

THE FIRST INSTALLATION OF THE APPLIANCE
AND SETTING THE STATIONARY FOOTS
DURING FIRST MOUNTING OF YOUR REFRIGERATOR
* Lay your refrigerator with a small angle to its back after you re-moved the pad lower
*(1) First, set the height of right stationary foot (the hinge side) untilthe distance
between the front side and the ground were 3-3.5cm after that put the refrigerator
on a flat and though ground.
*(2) Make sure the ground is firm and flat otherwise product might stay diagonally
unsecure which might cause opening/ levelling issues at doors.
*(3) After all set other stationary foot (left) until the refrigerator became balanced.
*(4) This tilted back position will allow the doors to self close and seal properly.
IMPORTANT !
3-3,5 cm
EN -19-
Hinge
Turning this way will lift the
product up
Turning this way will lift the
product down