EUROM Siena Manuel D'utilisation page 40

•
Hang the glass plate (two people are needed for this job!) with the four hooks over the
four knobs on the sides of the fireplace and check that all four hooks are correctly
attached (see diagram 4). Secure the glass plate by tightening the screw that goes
through the bracket (which sits on the glass plate).
•
Installation is now complete.
Note: ensure that the weight of the fireplace hangs on the wall supports and not on the
spacer bracket!
Operating
•
Check that the details on the data plate correspond to those of the electrical supply
which you wish to use for the fireplace. Do not use the same connection for any other
equipment.
•
Install two AAA-1,5V batteries in the remote control.
•
Check whether the main switch is set to OFF (O is pushed in)
•
Now insert the plug into the grounded socket.
•
Push the main switch to ON (I is pushed in). The stove is now on stand-by and
the light is switched on at the display
•
You can now further operate the
with the buttons on the fireplace itself.
Push-button operation
If you don't use the remote control, you can press the relevant buttons on the control
panel, manually set it to 3 positions; the corresponding lights will turn on.
- I/O : flame effect only
- I/O + 900W : flame display and heating at 900W
- I/O + 1800W : flame display and heating at 1800 Watt (all the lights are turned on).
By pressing the I/O button longer, you initiate the dimmer function; the light intensity will
increase or decrease with every tweet. Release the button when you have achieved the
desired intensity
Attention! The thermostat cannot be set manually, only with the remote control. The
thermostat is standard set to 20°C.
Remote control
• Press on the ON/OFF button to switch on the stove.
• Now set the desired temperature. The temperature & timer setting will usually show
the ambient temperature. By pressing on the + or - button, you see the set
temperature flashing for a short time and by pressing the + or - buttons, you can adjust
the temperature (from 15 to 30°C). After a few seconds, the display switches back to
the ambient temperature and the newly desired temperature is set. The temperature is
standard set to 20°C.
fireplace with the remote control or
40