Publicité
Les langues disponibles
Les langues disponibles
Operation
Main power switch
Use the main switch to turn on the electronic circuitry for
the control panel. The cooktop is now ready to use.
Turning the cooktop on
Touch the On/Off touch key until the indicator above the
main switch and the symbols
turn on.
Turning the cooktop off
Touch the On/Off touch key. The __ indicator goes out.
The cooktop is switched off. The residual heat indicators
will remain on until the elements have cooled off
sufficiently.
Note: The cooktop switches off automatically when all
the elements have been switched off for more than
10 seconds.
If residual heat is still present when the cooktop is turned
on,
/
will appear in the heating element display.
•
œ
Main power switch
Use the main switch to turn on the electronic circuitry for
the control panel. The cooktop is now ready to use.
Turning the cooktop on
Touch the On/Off touch key until the indicator above the
main switch and the symbols
turn on.
Turning the cooktop off
Touch the On/Off touch key. The __ indicator goes out.
The cooktop is switched off. The residual heat indicators
will remain on until the elements have cooled off
sufficiently.
Note: The cooktop switches off automatically when all
the elements have been switched off for more than 15
seconds.
If residual heat is still present when the cooktop is turned
on,
/
will appear in the heating element display.
•
œ
10
$
for the heating elements
for the heating elements
$
Setting the cooktop
This section will show you how to set the elements. The
table contains details on the heat settings for a variety of
dishes.
Setting the element
Select the desired heat level using the number keys 1 to
9.
Heat level 1 = minimum power
Heat level 9 = maximum power
Each heat setting has an intermediate level. This level is
indicated by . and is set with the
control zone.
Selecting the heat level
The cooktop must be turned on.
Touch the
$
touch key for the corresponding element.
1.
The
indicator will appear in the element display and
‹
the
symbol for the selected element will light up
$
brightly.
Within the next 10 seconds touch the desired heat
2.
setting (1-9) in the touch control zone.
Auto
Power
Keep
Programs
Chef
Start
Warm
3
4
Changing the heat level
Select the element and touch the number key for the
desired heat level. To select an intermediate level, touch
the
symbol located between the heat level numbers.
Û
Turning off the element
Select the element and set the heat level to 0. The
element is turned off and the residual heat indicator is
displayed.
Note: The heat is turned on and off to regulate the
temperature of the element; this means that the red glow
below the element is not always visible. When you select
a low heat setting, the element turns off for longer
intervals, while at a higher setting these intervals are very
short. Even at the highest level, the element turns on and
off.
keys in the touch
Û
Auto
Power
Keep
Programs
Chef
Start
Warm
5
3
4
5
Publicité
