Publicité
Les langues disponibles
Les langues disponibles
3.4. Transmitting and receiving
When the radio is switched on, it is automatically in receive mode as long as you are not transmitting.
When a radio message is received, the message RX appears in the display. Adjust the desired volume
with the VOL▲ and VOL▼ buttons. After 10 seconds of inactivity, the backlight turns off to save
power. The unit can still receive radio transmissions.
To transmit, press and hold the PTT (transmit) button and speak into the microphone at normal volume
and about 5 cm away. The message TX appears in the display. Release the PTT button at the end of
your transmission. To avoid accidental continuous transmission, the unit interrupts transmissions after
one minute and emits a warning tone instead. To continue transmitting, release the PTT button briefly
and then start another transmission.
Before transmitting, make sure the channel is clear by waiting a few seconds for any radio calls from
other participants.
4. Additional functions
The Tectalk Go has additional functions that you can use in the following way.
4.1. Main menu
Open the main menu by pressing the MENU button. Press the button again to move through the menu
items. To exit the menu, press the PTT key. The menu items are:
•
Call tones
•
Dual channel monitoring
•
SCAN
•
Key Lock
•
Key Tones
•
Roger Beep
•
Flashlight
4.2. Call tones
You can send call tones to attract the attention of other participants or to announce a transmission. The
type of call tone can be selected from 5 variants in the main menu item CA (Call announcement). To do
this, press the MENU button twice and select the desired tone with the VOL▲ and VOL▼ buttons. The
setting 0 completely deactivates the call tone function. Save the setting with the PTT button.
To send the selected call tone, press and hold the VOL▼ button during normal operation. The call
tone is transmitted as long as you keep the key pressed.
4.3. Dual channel monitoring
This function allows you to listen to a second channel in addition to the channel you are currently
listening to. If a radio message is received on one of the two monitored channels, it will be played back.
Note that you nevertheless always transmit on your set main channel. To answer on the secondary
channel, you must therefore change the main channel to it.
Configure the dual channel monitoring by pressing the MENU button four times until the dual channel
monitoring symbol
VOL▼ buttons and save the setting with the PTT button. The dual-channel monitoring is now active
until you deactivate it in this menu with the OF setting.
is displayed. Now select the desired second channel with the VOL▲ and
13
Publicité
