Publicité
Les langues disponibles
Les langues disponibles
Risk of injury! The trigger and safety le-
ver may not be locked during the oper-
ation.
Risk of injury! Contact Customer Ser-
vice if the safety lever is damaged.
Risk of injury from high-pressure water
jet. Slide the safety catch on the trigger
gun forward before performing any
work with the appliance.
CAUTION
Clean engines only at places with cor-
responding oil separators (environ-
mental safety).
Opening/closing the trigger gun
To open the trigger gun: Actuate the
safety lever and trigger.
To close the hand spray gun: Re-
lease the safety lever and trigger.
High pressure operation
The appliance can be operated in a
vertical or horizontal position.
Note:
The appliance is equipped with a pres-
sure switch. The motor starts up only
when the trigger gun is open.
Set the appliance switch to "I".
Release the trigger gun. To do so,
push the safety catch towards the
back.
Open the hand spray gun.
Select spray type
Close the hand spray gun.
Turn the casing of the nozzle till the
desired symbol matches the mark-
ing.
High pressure circular
spray (0°) for specially
stubborn dirt
Flat low pressure spray
(CHEM) for operating using
detergents or cleaning at
low pressure.
High pressure flat spray
(25°) for large dirt areas
Operation with detergent
WARNING
Unsuitable detergents can cause dam-
age to the appliance and to the object
to be cleaned. Use only those deter-
gents that have been approved by
Kärcher. Observe the dosage and oth-
er instructions provided with these de-
tergents. For considerate treatment of
the environment use detergent eco-
nomically.
Follow the safety instructions for using
detergents.
Kärcher detergents ensure smooth
functioning. Please consult us or ask
for our catalogue or our detergent in-
formation sheets.
Take out detergent suck hose.
Adjust the suction volume of the de-
tergent solution at the detergent fil-
ter.
Suspend end of suction hose in a
container filled with detergent.
Set nozzle to "CHEM".
Recommended cleaning method
Spray the detergent sparingly on
the dry surface and allow it to react,
but not to dry.
Spray off loosened dirt with the
high-pressure ray.
Set the suction flow on the deter-
gent filter to the maximum quantity
after operation.
Start the appliance and rinse for
one minute.
– 8
EN
11
Publicité
