Brandt BIL1770FB Manuel D'instruction page 53

Troubleshooting
Warning! If there is any anomaly, unplug your appliance. Only a qualified electrician or
competent person may carry out troubleshooting.
If there is any anomaly during operation, check the following points before calling our approved after
sales service or a qualified professional.
ERROR MEANING
TYPE
E01 Sensor warning
E02 Sensor warning
E03 Sensor warning
E06 Sensor warning
E07 Sensor warning
E08 Low voltage
warning
E10 Fridge
compartment is
not cold enough
E11 Fridge
compartment is
too cold
WHY
Power supply to the
device has dropped
to below 170V.
Likely to occur after:
- Long term power
failure.
- Hot food has been
left in the fridge.
Various
WHAT TO DO
Call Service for assistance as soon as
possible.
Call Service for assistance as soon as
possible.
Call Service for assistance as soon as
possible.
Call Service for assistance as soon as
possible.
Call Service for assistance as soon as
possible.
- This is not a device failure, this error helps
to prevent damages to the compressor.
- The voltage needs to be increased back to
required levels.
If this warning continues, an authorised
technician needs to be contacted.
1. Set the fridge temperature to a colder
value or set Super cool. This should remove
the error code once the required
temperature has been reached. Keep doors
closed to improve time taken to reach the
correct temperature.
2. Please empty the location at the front
area of air duct channel holes and avoid
putting food close to the sensor.
If this warning continues, an authorised
technician needs to be contacted.
1. Check if Super cool mode is activated
2. Reduce the fridge compartment
temperature
3. Check if vents are clear and not clogged
If this warning continues, an authorised
technician needs to be contacted.