Publicité
Les langues disponibles
Les langues disponibles
CAUTION:
Extreme care should be taken NOT to scratch the bubble dome
surface while the camera installing or adjusting.
Care should be taken the cable is NOT to be damaged, kinked or
exposed in the hazardous area.
Tighten enough the dome cover fixing screws so that there
should be NO gap between Lens hood and clear bubble to avoid
the light inflow from IR LEDs.
Power supply connections
Make sure the power is removed before the installation. Camera can work with either
24VAC or 12VDC, dual voltage power. Primary and secondary grounds are completely
isolated to avoid the possible ground-loop problems.
Please use the cable as provided with camera. If camera cable is cut and re-wired,
i
the transmission distance of video can be reduced. Especially SDI cable should not be cut
because it requires detailed wiring job and affects the transmission distance.
SDI output (Yellow)
Analog output (Black)
Power ( 24VAC/12VDC)
AC
AC
AC(+): 24VAC/12VDC
(+)
(-)
AC(-): 24VAC/GND
EN
9
Publicité
