Publicité
Les langues disponibles
Les langues disponibles
Installation instructions
CAUTION: The camera's base should be attached to a structural
object, such as concrete, hard wood, wall stud or ceiling rafter
that supports the weight of the camera. If necessary use appro-
priate mounting material (e.g. anchors) instead of the material
enclosed with the camera.
1. Locate the mounting template at the installation position and drill the ceiling or
wall if needed.
2. Open the dome cover by loosening screws (4x12mm). Use the torque wrench
supplied.
• Place the dome base unit on pre-drilled position and fix it through using mounting
screws (4x30mm).
• Route the Power cable to the connecting place.
• In the case of installation with optional mounting accessories (Surface mount or
Tilted mount), the power cable should be fixed to the flush mount by using the
fixing screw and cable holder.
3. Connect the dome cable with the power source cable.
4. Set the camera's viewing angle.
5. Put the dome cover to the dome base unit and tighten the assembly screws.
Torque Wrench
Mounting Screw (4x30mm)
Assembly Screw (4x12mm)
EN
7
Publicité
