SPIDO SPR 500 Mode D'emploi page 13

To be checked before you start
The pump is made for swimming pool equipment.
The pump has to be fixed on a plane and solid surface
The pump is made for clear water circulation, with a temperature below
35°C
This pump is only made for swimming pools and basins that comply with
IEC 60364-7-702 regulation, and the national regulations where the pump
is installed
Your pump SPR 500
11. Drainage cap
12. Pump housing
13. Tightening wheels
14. Water input. Suction connector:
Ø 32-38 mm
15. Water output. Delivery connector:
Ø 32-38 mm
Your pump SPR 800
10. Drainage caps
11. Pump housing
12. Filter cap
13. Water input. Suction
connector: Ø 50 mm
Getting started
ELECTRIC SHOCK:
Before filling the pump, or before any maintenance operation, unplug the
pump from the mains
- Install the pump in a place protected from rain and floodings, with
sufficient air flow
16. Electric box
17. Motor
18. Foot / Base
19. Filter
20. Cap of the filter
14. Water output. Delivery
connector: Ø 50 mm
15. Electric box
16. Motor
17. Foot / Base
18. Filter
F GB