Dog trace d-control 300 Aqua Spray Mode D'emploi page 9

Inserting (changing) the receiver battery
1. Remove the 4 screws from the underside of
the receiver and remove the lid from the top.
2. Insert the lithium CR2 3 V battery with the
correct polarity (polarity is marked in the
battery compartment).
When inserting battery for the first time, or
if the battery is removed for longer than a
couple tens of minutes (approx. 20 minutes),
a beep sounds to indicate that battery has
been inserted correctly.
Note: When the battery is replaced quickly,
the beep may not sound.
3. Check that the rubber seal is correctly
positioned in the receiver lid groove. If the
rubber seals are dirty, clean them.
4. Put the lid back on the receiver and replace
the screws.
Checking the receiver battery's status
To check the receiver battery, see the indicator light (LED) on the upper side of the
receiver (see chapter): Product description - Receiver.
Charged battery – when on, the LED flashes green
Low battery – when on, the LED flashes red
If the battery is flat, insert new lithium battery CR2 3 V into the battery compartment.
Switching the receiver on/off
To turn the receiver on/off (e.g., when pairing the transmitter and receiver), use the
magnetic switching system, activated by
placing the magnet stored in the lower part
of the transmitter near the correct receiver
part.
Switching on:
1. Place the lower part of the transmitter near
the red target on the receiver (see picture)
- indicator light will shine red, then orange.
2. Once the light is orange remove the
transmitter from the receiver - the light
will shine green and start to flash.
RECEIVER PREPARATION
9