Dog trace d-control 300 Aqua Spray Mode D'emploi page 11

Filling the receiver with spray
Before using the spray training collar, you must fill the receiver
tank with spray.
1. Turn off the receiver.
2. Remove any dirt from the refill port.
3. Turn the receiver so the refill port points upwards.
4. Place the spray tip on the refill port as shown.
5. Press the spray bottle lightly into the container and hold for
about 15 seconds.
6. Stick the stick-on label that is under the cap of the spray
bottle over the refill port.
Warning: The spray refill port must be protected against any
dirt in order to work properly. It is important to stick the label
over the refill port after every refill. This will protect the refill
port against dirt.
Warning: Do not try to fill the receiver
while the dog is wearing the collar. To fill
the d-control AQUA spray receiver use
only original Dogtrace brand spray.
Fitting the training collar
Fitting the collar and receiver correctly is
important for proper functioning. Place the
dog collar so that the spray nozzle points
toward the dog's nose. The collar strap is
properly adjusted if you can insert 2 fingers
between the collar and the dog's neck. If
your dog has dense or long hair, it may
be necessary to trim it to ensure the spray
reaches the nose area.
BASIC USE OF THE TRAINING COLLAR
An important prerequisite for the use of the training collar is the trainer's basic
knowledge of dog training.
If you do not have this knowledge, please turn to a training center, cynology club
or dog school where you will learn basic communication with your dog.
You may begin using the training collar with a 6-month-old puppy that already
has some basic training, e.g., "SIT", "LIE DOWN", "STAY" or at least "NO"...
15 s
Spray
nozzle
11