Lubrication - Joerns Oxford Presence Manuel De L'utilisateur

Oxford
®
Presence
*THESE CHECKS SHOULD INCLUDE:
1. SPREADER BAR: Check the spreader bar for freedom of rotation and swing.
Check for wear on the central pivot. Check for firm attachment to the boom.
2. BOOM: Check the attachment of the boom to the mast. Make sure there is
only minimal side movement of the boom and the boom is free to rotate on the
boom bearing.
3. MAST: Check the operation of the mast-locking device. Make sure the mast
fully engages into the socket. Check the bottom actuator.
4. ACTUATOR: The actuator should require no maintenance other than
checking for correct operation and listening for unusual noise.
5. SMART MONITOR: Check the function of the emergency stop button. Inspect
the hand control socket for correct fitting. Check functioning of the hand
control. Check the redundant controls and confirm they operate as intended.
6. BATTERIES: The batteries are housed in the power pack and should not
require maintenance other than the regular charging as detailed in the
charging instructions. Check that the connections remain clean.
7. LEG ADJUSTMENT: Check the legs operate in both full extensions (inward/
outward).
8. CASTORS: Check all castors for firm attachment to the legs. Check for free
rotation of the castor and the wheels.
9. CLEANING: Clean with ordinary soap and water and/or any hard surface
disinfectant. Harsh chemical cleaners or abrasives should be avoided as these
may damage the surface finish of the lift. Avoid wetting any of the electrical
parts. After cleaning, the unit should be thoroughly dried.
10. LOAD TEST: The load test should be carried out in accordance with
the manufacturers test procedures and the directive detailed in EN ISO
10535:2006 - Annex B - Periodic Inspection B1 - see excerpt below. It is
strongly recommended that an authorised service dealer carry out the test.
11. BASE AND WHEELS: Ensure base is even and level (all four wheels are on
the floor).
12. SLINGS: Check for wear and fraying.
13. LUBRICATION: Oil pivot joints, including mast and boom connections, pedal
assembly, spreader bar joint (only if required).
14. HAND SET: Ensure plugged fully into controller.
15. QUICK RELEASE PIN: Ensure the pin is securely fitted before lifting, by
pressing the barbed end.
16. FIXINGS: Check all nuts, bolts, screws and fasteners for excessive wear and
for tightness. Replace as required.
17. INTEGRATED APC: (Model specific).
Check the Integrated APC operates in both directions via the hand control.
The actuator should require no maintenance other than checking for correct
operation and listening for unusual noise.
26
English
ü ü ü
ü ü ü
ü ü ü
ü
ü ü ü
ü
ü ü ü
ü ü ü
ü ü
ü
ü ü ü
ü ü ü
ü
ü ü
ü ü
ü
ü ü ü