Technical Data; Transport And Storage; Storage; Installation And Commissioning - Trotec Airozon Supercracker Mode D'emploi

8. Technical Data

Parameter
Electrical connection
Frequency
Nominal current max.
Power consumption
Power consumption max.
On-site fuse protection
Operating range temperature
Width
Depth
Height
Weight
Ozone performance
Air flow rate
Air humidity

9. Transport and storage

Transport
Caution!
Damage to device due to vibra-
tions.
Strong vibrations can cause
damage to the electrode.
Make sure to always secure the
odour neutraliser during trans-
port in order to protect it against
vibrations and to prevent it from
slipping.

Storage

Store the Airozon Supercracker in a dry place where it
is protected from adverse weather effects.
Choose a storage location that is free of dust.
EN
Always disconnect the device from the mains supply
when it is not in use.

10. Installation and commissioning

Value
230 V
The following requirements must be met when in-
50 Hz
stalling the odour neutraliser:
1.5 A
0.18 kW
0.3 kW
5 A
10 - 40 °C
400 mm
600 mm
890 mm
20 kg
10,000 mg/h
500 m³/h
max. 80 %

11. Functions and operation

Fig.: Rear side
Operating manual – Airozon Supercracker
Connect the Airozon Supercracker to a power
supply source located outside of the room
to be treated. This way, the device can be
switched off in case of emergency without
having to enter the room.
Only use the ozone generator according to the
parameters provided in the chapter "Techni-
cal data".
Make sure that the air inlet and air outlet are
not covered.
If possible, position the device in the centre
of the room in order to ensure an optimum
air circulation.
Do not install the device near inflammable
substances or gases.
Make sure that the device is placed on a dry
and non-vibrating surface.
Make sure that the device is protected against
splash water.
The room temperature should be approx. 5 °C
above the normal room temperature.
1
B-5