Publicité
STEP 2
Measure the cabinet opening
and then measure the door size.
Take the difference of these two
numbers and divide it by 2. This
number is the door overlay or inset
gap (See Figure 11).
STEP 3
If the door is larger than the
opening, ADD the door overlay
to the Step 1 dimensions. If the
door is smaller than the opening
SUBTRACT the inset gap from the
Step 1 dimensions. Mark screw
locations to the center of the thick
portion of the door, pre-drill pilot
holes, and attach door with (4)
6 x ½" Flat Head Screws
(See Figure 12).
NOTE: Minor adjustments like
skew and tilt can be made on the
bracket mounting bolts
(See Figure 13).
FIG. 11
Difference ÷ 2
(overlay or inset)
FIG. 12
INSTALLATION INSTRUCTIONS: DOUBLE 35/50 QT WASTE MANAGEMENT SYSTEM
Cabinet
opening
Difference
Mark screw locations
Door size
FIG. 13
T-Nut Screw
5
Publicité
