Publicité
STEP 6
Attach the slide triggers to the
bottom of the wood frame, using
(4) #6 x ½" Pan Head Deep Thread
Screws, into the predrilled holes on
the same side as the door mount
brackets (See Figures 6A and 6B).
STEP 7
Place template into cabinet and
position the front edge to where
the back of the door will be when
closed (See Figure 7) inset door =
set back the thickness of your door,
overlay door = place at the front
edge of cabinet.
Using an awl or pencil, mark
through the bold dotted screw
locations onto your cabinet floor.
Remove template when done.
Using your
⁄
" drill bit, pre-drill
3
32
in all (8) locations making sure to
NOT drill through the cabinet floor
completely.
Lay your assembled slide set over
the top of the marked holes. Using
(8) #6 x 1" Deep Thread Phillips
Head Screws, attach the slides to
the cabinet floor through the gray
slide feet holes. Place your wood
frame with attached triggers on top
of the slides and push back until you
hear the "click" sound.
FIG. 6A
FIG. 7
3
32
INSTALLATION INSTRUCTIONS: DOUBLE 35/50 QT WASTE MANAGEMENT SYSTEM
Pre-drilled holes
FIG. 6B
3
Publicité
