Publicité
Les langues disponibles
Les langues disponibles
INSTALLATION
Preparing the chargers
Power Sharing Cabling
Connecting your chargers for Power Sharing requires installation of
communication cabling. This cabling may be drawn through either of
the following pathways:
Center opening
Use the small opening located at the
bottom of the charger between the
power input and the EV connector
cable output.
When using this opening for the
communications cabling, first remove
the screw plug.
Use a wrench to hold the interior lock
nut while unscrewing the plug using a
flathead screwdriver from the bottom
(exterior) side of the plug.
Power input opening
When allowed by local codes, run the
data cable in the same power supply
conduit (same conduit used for the
hardwired electrical wiring).
or
9
Publicité
