Pulsar PRO POWER SHARING Mode D'emploi page 16

SETTING UP - PUP3
Primary Charger
Once you have added the chargers you are connecting to the Power Sharing
system, stand in close proximity to the PRIMARY charger with your mobile
device and Bluetooth switched on.
1.
Launch the myWallbox app on your mobile device and log in.
2.
From the list of chargers, select the charger you have setup as the
PRIMARY charger.
3.
Click the Configurations (gear) icon and then, from the Configurations
screen, select "Installation Options" and then select Upgrades.
On the Power Sharing screen, you will need to adjust the following
settings:
1. Number of chargers. This is the TOTAL
number of chargers in the Power Sharing
system including the Primary charger.
2. Maximum current per system (phase).
This is the maximum amount of power
available for all chargers connected to the
Power Sharing system.
Be reminded that the system must be
connected to a circuit rated to 125% of the
maximum power dedicated to the chargers.
For example, if the total power available to
chargers is 200Amps, the circuit must be
rated to 250Amps.
3. Minimum current per charger. The default
value is set at 6 Amps; however, some
vehicles require a minimum current of
10Amps.
4.
After you have entered all values, click "Save". It may take up to a
minute for the system to complete configuration.
1
2
3
16