Pulsar PRO POWER SHARING Mode D'emploi page 18

OPERATING - PUP3
Status
Status Text
PRIMARY CONFIG-
URED WITH ALL
SECONDARIES PAIRED
POWER SHARING
ACTIVATED
PRIMARY CONFIG-
URED WITH SOME
SECONDARIES NOT
PAIRED
UNCONFIGURED
POWER SHARING
PRIMARY NOT CON-
FIGURED
PRIMARY NOT PAIRED
SECONDARY PAIRED
WITH NETWORK
SECONDARY NOT
PAIRED WITH NET-
WORK
POWER SHARING
ACTIVATED
WAITING ASSIGNA-
TION
Shown in Description
Displays only for Primary charger.
Power
Sharing app The network has been successfully set.
screen
All chargers are connected with the Primary.
The network has been successfully set.
Charger app
home screen
The unit is connected to the primary unit.
Shows only for Primary charger.
The network has been successfully set. Some Sec-
ondary units are not connected.
Power Sharing
Verify that the setting "number of chargers" in Pri-
app screen
mary unit coincides with the number of chargers in
the system. Check the bus communications cables
between the chargers.
This is the initial status after powering on the set-
Charger app
up.
home screen
The unit is paired with the Primary unit but it de-
Power
tects that it is pending to be configured.
Sharing app
The chargers will blink in red.
screen
Shows only for Secondary chargers.
The number of chargers in the configuration are
Power
not consistent with the ones that are connected
Sharing app
with the Primary. Review "Configuring the Primary
screen
Charger" and ensure all steps are completed cor-
rectly.
Power
Secondary connected with the Primary. The instal-
Sharing app
lation has been successful.
screen
The Secondary chargers are not successfully con-
nected with the Primary charger on the Power
Power Sharing
Sharing network. This may occur if the system can-
app screen
not successfully communicate with the chargers
within 30 seconds.
In this state, the charger LED halo will blink fast and
Secondary chargers will be limited to 6 Amps.
Insufficient power is available to this charger. This
may occur if all available system power is already
assigned to other connected chargers/vehicles.
Charger app
As other vehicles complete charging or are dis-
home screen
connected, when the minimum power is available,
this charger will begin charging. The charger LED
halo will pulse blue, indicating an active charging
session.
18