Pulsar PRO POWER SHARING Mode D'emploi page 10

INSTALLATION
Wiring
For Power Sharing, the chargers communicate through a daisy-chain cabling
system. When connecting three or more chargers, the first and last chargers of the
chain will be Terminating (T) chargers and the chargers in between will be Non-
terminating (NT) chargers as shown in the figure below. (Note: when connecting
only two chargers, both will be Terminating.)
T
Installation
Draw the communication cables between the chargers through the selected
conduit (see Preparing the Chargers section above) as shown below. Ensure that
the total length of the cable is no more than 820 feet (~250m)
The cabling consists of a daisy chain of a twisted pair of wires connecting the
chargers.
T
T
NT NT
NT
NT
NT T
NT
The cabling cabling position and
polarity must always be respected.
T
10