Pulsar PRO POWER SHARING Mode D'emploi page 8

INSTALLATION
Preparing the chargers
Before proceeding with Power Sharing setup, you should install the chargers
according to the instructions as included in the charger's Installation Guide.
Note that depending on the type of charger installation (hardwired or NEMA
plug), you will have additional instructions as described below:
For NEMA plug-in installations, you typically will not have to open the
charger; however, to setup plug-in chargers for Power Sharing, you will need
to open each connected charger in order to perform some of the steps in this
set-up. Refer to Pulsar Plus Installation Guide for more information on how to
open the charger.
After you have mounted your charger according to the instructions in the
Installation Guide, ensure:
•
The charger cover is not attached to the charger (disconnect
the communications cable from the cover).
•
The chargers are electrically wired (connected to a circuit).
•
Any connected circuits are NOT powered on during installation.
To make handling of the chargers, cables, and connectors easier during the
Power Sharing setup, you may want to install the holsters before proceeding.
See the "Installing the Holster" section in the charger Installation Guide.
Important ensure that all of the chargers on the same Power Sharing net-
work are wired to the same electrical feed and share the same grounding
system.
8