Pulsar PRO POWER SHARING Mode D'emploi page 14

SETTING UP - PUP3
Primary Charger
Once the installation has been powered on, the Power Sharing
configuration must be finalised with the myWallbox app on the Primary
charger:
For PUP3, select any unit to configure, and that charger will automatically
become the Primary.
Until the network is properly configured, the chargers will remain in the
"UNCONFIGURED POWER SHARING" status.
Important: If you are installing a Dynamic Power Sharing with a Power Meter,
you must select the unit which has the meter wiring connected as the Prima-
ry to perform the network configuration.
myWallbox App and Account
To connect to the chargers and complete the configuration, you need to
download the myWallbox app, create an account (in case the infrastructure
manager doesn't own one already or you cannot access it), and connect to
the Primary charger via Bluetooth. See the charger Installation Guide for
instructions for downloading the app and setting up a myWallbox account.
If you use your own account for setup, remember to UNLINK your account
from the charger after system configuration to enable the owner's man-
agement of the chargers.
14