Cooke & Lewis 3663602553052 Mode D'emploi page 30

02
General Use
Light On/Off
- Use this control to switch the light on independently of the fan motor, it will be lit red in this mode.
- When the fan is in use, and the light is off, the icon will be lit white in this mode, but will turn red if
the light is then switched on.
Fan On/Off and Speed Reduction
- Press this icon once to turn on the fan motor at speed 1. All icons will be lit white and the light icon
will be red if already in use.
- If the motor is on speed 1, pressing and holding this icon for two seconds will turn off the fan motor.
As above, the light control is independent of this operation.
- If the motor is higher than speed 1, this will reduce the fan speed with each press of the icon.
LED Display
- Shows the extraction mode during set up
Boost Function and Speed Increase
- Press this icon once to turn on the fan motor at full power, and P will fl ash in the display,
- If the motor is already on speed 1-5, each press of this icon will increase the fan speed accordingly.
- If you press and hold the icon for two seconds, the fan speed will increase to full power and P will
fl ash in the display.
NOTE: Full power or Boost only operates for fi ve minutes maximum to conserve energy
and the fan speed will automatically drop to speed level 5 after this time.
Timer
- When the fan motor is on and the Timer
current speed in the display will start to fl ash.
- The chosen speed level will remain in use for fi ve minutes before dropping down to the next lowest
speed. This speed will remain in operation for two minutes before dropping down again. This will be
repeated every two minutes unless the speed is already at level 1 and then the fan will turn off. If
the light is already on, this will also be turned off.
- Pressing the Speed Reduction
restart the countdown process again with a fi ve minute cycle.
- If the Timer icon is pressed again during a current timer program, the cycle will be cancelled, the
icon will revert to white and the current fan speed will remain on indefi nitely.
- The maximum timer program cycle is 15 minutes: 5 minutes on P and then 2 minutes each on
speed 5 down to speed 1.
and the motor speeds from 1-5, and P for Boost.
or
icon is pressed, the icon will be lit red and the
or Speed Increase icon during a current timer program will
30