Abus FU8165 Instructions D'installation page 35

8.7. Button functions of arming station on the wireless
alarm system
The left button (11) on the wireless key switch is used for activation, and
always sends the "Button 1" code. This button corresponds to button 1 in
the Secvest installer menu ("Other Devices"  "Arming station"  "Edit
Arming Station").
The right button (12) on the wireless key switch is used for activation, and
always sends the "Button 4" code. This button corresponds to button 4 in
 
the Secvest installer menu ("Other Devices" "Arming station" "Edit
Arming Station").
The arming station buttons on a Secvest wireless alarm centre have the
following default settings (software versions 2.xx.yy and 3.xx.yy):
Button 1: Full Set All
Button 4: Unset All
You do not need to make any changes under this menu item on the centre
to activate and deactivate the Secvest FU500x wireless alarm centre
(software versions 2.xx.yy and 3.xx.yy).
The Secvest 2WAY wireless alarm centre has a different default setting for
the button functions on the arming station. The button function has been
adapted to the button marking of the new arming station (FU8110).
The arming station buttons on a Secvest 2WAY wireless alarm centre have
the following default settings (software version 5.xx.yy):
Button 1: Full Set All
Button 4: Not Used
Important!
If this wireless key switch is used with the Secvest 2WAY FU800x,
then button 4 must be reprogrammed to "Unset All" (software version
5.xx.yy).
The transmitted button codes of the wireless key switch are not freely
programmable.
35