Abus FU8165 Instructions D'installation page 33

Important:
Note that if you want to activate several partitions, you have to assign the
same types and delay times to the partitions, when you program your
Secvest wireless alarm system.
8.6. Training and removing the wireless key switch
The wireless key switch is trained as a normal wireless operating panel
for the wireless alarm system. You also have to carry out the operating
steps for training a wireless alarm system for an Info module.
8.6.1 Training and removing the wireless key switch for the
alarm centre
1. In Installer mode, select "Other devices  Arming station 
Add/Del Arming station" and then select a wireless operating panel.
Send the training signal from the wireless key switch to the wireless
alarm system by repeatedly pressing a tamper switch.
2. When the training signal is received by the wireless alarm system,
it emits a double tone and the
selected wireless operating panel.
3. Exit this menu item.
Important:
To remove the wireless key switch, select in installer mode "Other devices
 Arming station  Add/Del Arming station." Select the corresponding
wireless operating panel and delete it by following the instructions on the
display.
symbol appears behind the
33