Chauvet Professional MAVERICKMK2WASH Mode D'emploi page 49

Operation
Preset sync
To sync all menu presets to other Maverick MK2 Washes, follow the instructions below:
1. Connect all Maverick MK2 Washes via DMX cable.
2. Navigate to the Setup
3. Use <UP> or <DOWN> to select Preset Sync, or touch the display where it says Preset Sync.
4. If using the buttons instead of the touchscreen, press <ENTER>.
5. Select YES or touch the display where it says the desired option.
6. Press <ENTER>.
• To sync other Maverick MK2 Washes, you connect those products by a DMX cable.
• The product can be in any control mode except WDMX. ArtNet, DMX, sACN are all
acceptable.
• All menu options are transferred, including the DMX address. Only the IP address in not
affected in the other products.
Only connect Maverick MK2 Wash.
Reset functions
To reset the pan, tilt, or all functions as if from startup:
1. Navigate to the Setup
2. Use <UP> or <DOWN> to select Reset Function, or touch the display where it says Reset
Function.
3. If using the buttons instead of the touchscreen, press <ENTER>.
4. Use <UP> or <DOWN> to select the function to reset, from Pan, Tilt, or All, or touch the display
where it says the desired option.
5. If using the buttons instead of the touchscreen, press <ENTER>.
6. Use <UP>, <DOWN>, <LEFT>, or <RIGHT> to select from NO (do not reset) or YES (reset), or
touch the display where it says the desired option.
7. Press <ENTER>.
Factory reset
To restore the Maverick MK2 Wash to factory default settings, do the following:
1. Navigate to the Setup
2. Use <UP> or <DOWN> to select Factory Settings, or touch the display where it says Factory
Settings.
3. If using the buttons instead of the touchscreen, press <ENTER>.
4. Use <UP>, <DOWN>, <LEFT>, or <RIGHT> to select NO (do not reset) or YES (reset to factory
settings), or touch the display where it says the desired option.
5. Press <ENTER>.
System information
All information about the current status of the Maverick MK2 Wash is available through the product's Sys
Info menu. To view this information, follow the instructions below:
1. Press <MENU> repeatedly until the
2. Use <UP>, <DOWN>, <LEFT>, or <RIGHT> to select Sys Info, or touch the display where it says
Sys Info.
3. If using the buttons instead of the touchscreen, press <ENTER>.
4. Use <UP> or <DOWN> to select from Fixture Information (shows firmware version, running
mode, starting address, etc.), Fan Information (shows speed of the head fans in rpm), Error
Information (shows any errors or No Error!), or Channel Information (shows the current value
of all signal input channels), or touch the display where it says the desired option.
5. Press <ENTER>.
6. Use <UP> or <DOWN> to scroll through the information.
Maverick MK2 Wash User Manual Rev. 15
menu.
menu.
menu.
Home Screen shows on the display. Press <ENTER>.
Page 34 of 197