Chauvet Professional MAVERICKMK2WASH Mode D'emploi page 46

Lock screen
To completely lock or unlock the control panel, follow the instructions below:
1. Navigate to the Setup
2. Use <UP> or <DOWN> to select Lock Screen, or touch the display where it says Lock Screen.
3. If using the buttons instead of the touchscreen, press <ENTER>.
4. Use <UP>, <DOWN>, <LEFT>, or <RIGHT> to select NO (control panel will not lock) or YES
(control panel will require a passcode to access), or touch the display where it says the desired
option.
5. Press <ENTER>.
To access the control panel when it has been locked:
1. Press <MENU>.
2. Enter the passcode 0920 using one of the following methods:
• Through the touchscreen: use the number pad on the screen to enter 0920.
• With the buttons:
a. Use <DOWN> to select the number to be changed.
b. Use <UP> to increase the value.
c. Repeat until 0920 has been entered.
3. Press <ENTER>.
Swap pan and tilt
To switch the pan and tilt functions so that what normally controls the pan controls the tilt and what
normally controls the tilt controls the pan, do the following:
1. Navigate to the Setup
2. Use <UP> or <DOWN> to select Swap XY, or touch the display where it says Swap XY.
3. If using the buttons instead of the touchscreen, press <ENTER>.
4. Use <UP>, <DOWN>, <LEFT>, or <RIGHT> to select NO (normal pan and tilt) or YES (pan
controls tilt, tilt controls pan), or touch the display where it says the desired option.
5. Press <ENTER>.
Pan/tilt speed
To set the maximum speed of the pan and tilt:
1. Navigate to the Setup
2. Use <UP> or <DOWN> to select XY Mode, or touch the display where it says XY Mode.
3. If using the buttons instead of the touchscreen, press <ENTER>.
4. Use <UP>, <DOWN>, <LEFT>, or <RIGHT> to select Slow or Fast, or touch the display where it
says the desired option.
5. Press <ENTER>.
WDMX reset
To reset the WDMX connection from the Maverick MK2 Wash, do the following:
1. Navigate to the Setup
2. Use <UP> or <DOWN> to select WDMX Reset, or touch the display where it says WDMX Reset.
3. If using the buttons instead of the touchscreen, press <ENTER>.
4. Use <UP>, <DOWN>, <LEFT>, or <RIGHT> to select NO (do not reset connection) or YES (reset
the connection), or touch the display where it says the desired option.
5. Press <ENTER>.
Once a WDMX receiver has been linked to a specific WDMX transmitter, it will remain
linked to that specific transmitter until it is linked to a different one.
Backlight timer
To set the amount of time after inactivity before the display backlight turns off:
1. Navigate to the Setup
2. Use <UP> or <DOWN> to select Backlight Timer, or touch the display where it says Backlight
Timer.
3. If using the buttons instead of the touchscreen, press <ENTER>.
4. Use <UP>, <DOWN>, <LEFT>, or <RIGHT> to select 30S (after 30 seconds of inactivity), 1M
(after 1 minute of inactivity), 5M (after 5 minutes of inactivity), or ON (does not turn off), or touch
the display where it says the desired option.
5. Press <ENTER>.
Page 31 of 197
menu.
menu.
menu.
menu.
menu.
Maverick MK2 Wash User Manual Rev. 15
Operation