Chauvet Professional MAVERICKMK2WASH Mode D'emploi page 32

Dual control pixels start address
To set the starting address of the Dual Control Pixels mode, set the Protocol, then follow the instructions
below:
1. Use <UP> or <DOWN> to select Start Address, or touch the display where it says Start Address.
2. If using the buttons instead of the touchscreen, press <ENTER>.
3. Enter the starting address (1–512) with one of the following methods:
• Type the address number using the number pad that shows on the touchscreen display.
• Using the buttons (or the button icons on the sides of the display):
a. Use <LEFT> or <RIGHT> to select the digit to be altered.
b. Use <UP> or <DOWN> to increase or decrease the number value of that digit.
c. Repeat until the address is set as desired.
4. Press <ENTER>.
Dual control pixels universe
To set the Universe address of the Dual Control Pixels mode when using Art-Net™ or sACN, set the
Protocol to ArtNet or sACN, then do the following:
1. Use <UP> or <DOWN> to select Universe, or touch the display where it says Universe.
2. If using the buttons instead of the touchscreen, press <ENTER>.
3. Enter the universe address (0–254 for Art-Net™, 0–255 for sACN) with one of the following
methods:
• Type the address number using the number pad that shows on the touchscreen display.
• Using the buttons (or the button icons on the sides of the display):
a. Use <LEFT> or <RIGHT> to select the digit to be altered.
b. Use <UP> or <DOWN> to increase or decrease the number value of that digit.
c. Repeat until the address is set as desired.
4. Press <ENTER>.
Control Values
Zones for Pixel Control
Page 17 of 197
6
5
4 11 12
10
3
2
7
8
9
1
Maverick MK2 Wash User Manual Rev. 15
Operation